F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Steering Gear: Initial Inspection and Diagnostic Overview
1. If damaged, remove and install a new poppet fixed stop screw and washer. Tighten to specification.
2. If damaged, remove the poppet adjusting screw and sealing nut without allowing the nut to change its position on the screw.
3. Assemble the new nut onto the new adjusting screw, matching its position to the nut and screw removed. Tighten the sealing nut to specification.
4. NOTE: If damaged, remove and install a new permanent auxiliary port plugs and O-rings.
Assemble new O-rings on the port plugs and tighten to their respective ports in the housing or valve housing to specification.
5. If damaged, remove the grease fitting from the housing. If the fitting is broken off, use the suitable extractor to remove it.