F 250 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
6. Remove the bolt and the transfer case control lever assembly. Discard the bolt.
Installation
CAUTION: Carry out this procedure only if reinstalling the original transfer case control lever assembly. If installing a new transfer case control
lever assembly, refer to Transfer Case Shift Over-New Assembly.
1. CAUTION: Do not tighten the bolt that attaches the transfer case control lever assembly to the transmission case at this time.
Align the new transfer case control lever assembly pivot bolt over the correct mounting hole in the transmission case and start the bolt into the
threaded hole by hand.
1
For vehicles with a gasoline engine and manual transmission, or a diesel engine and manual or automatic transmission, install the new bolt in
the forward (LH) threaded hole in the transmission case.
2
For vehicles with a gasoline engine and automatic transmission, install the new bolt in the rearward (RH) threaded hole in the transmission
case.
2. Position the detent plate locating pin in the unused threaded hole in the transmission case.
1
For vehicles with a gasoline engine and manual transmission, or a diesel engine and manual or automatic transmission, position the pin in the
rearward (RH) threaded hole in the transmission case.
2
For vehicles with a gasoline engine and automatic transmission, position the pin in the forward (LH) threaded hole in the transmission case.
