F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Front Door Window Regulator: Service and Repair
Manual Window Regulator
Crew Cab
REMOVAL
1. Remove front door trim panel and front door trim shield, if equipped.
2. Support front door window glass in the full up position.
3. Remove center pin rivets attaching front door window regulator with drift punch.
4. Drill head from each rivet using a 6.35-mm (1/4-inch) drill and remove rivet.
NOTE: Be careful not to damage sheet metal holes during drilling.
5. Disengage window regulator arm roller from front door glass channel and retainer and remove the front door window regulator.
INSTALLATION
1. Position the front door window regulator in front door and insert window regulator arm roller into front door glass channel and regulator.
2. Position the front door window regulator to inner front door panel and install rivets using Rotunda Blind Fastener Installation Tool 107-R0600 or
equivalent to attach the front door window regulator to front door inner panel. A 1/4-20 x 112 inch screw and washer assembly and a 1/4 20 nut
and washer assembly may be used in place of the rivets if rivets are not available (equivalent metric retainers may also be used).
