F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
7. Inspect disc brake caliper.
INSTALLATION
1. Install caliper slide pins through disc brake caliper and front wheel spindle. Tighten bolts to 22-40 Nm (16-30 ft. lbs.).
2. If front brake hose was removed, replace both washers (each side of inlet block). Connect the front brake hose. Tighten inlet block bolt to 30-4
(22-30 ft. lbs.).
3. Install wheel and tire assembly. Remove the safety stands and lower the vehicle.
4. If the brakes were not bled and disc brake caliper was not removed, check the fluid level in the brake master cylinder reservoir and fill if required.
5. Pump the brakes several times to make sure of a firm brake pedal.
6. Operate the vehicle to check brake operation.