F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
![background image](/ford/f_350_2wd_pickup/v8-460_7.5l_vin_g_efi/Page-2131001.png)
Compressor Fitting HVAC: Service and Repair
Inspection and Assembly Requirements
NOTE: Any time a hose or component connection leak is observed, to correctly service the leak, the connector fitting must be separated, cleaned and a
new O-ring installed. The O-ring and connector surfaces should be lubricated with clean refrigerant oil prior to assembly.
O-ring seal surfaces must be free of dirt, lint, burrs and scratches.
All O-rings must be lubricated with clean refrigerant oil immediately prior to installation.