F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Fuel Line Coupler: Service and Repair
Spring Lock Coupling
NOTE: The spring lock coupling tool will not always fit over the shielded tube. To accommodate the shielding, the hole in the tubing end of the tool
must be enlarged. To do this, clamp the tool closed and drill out the existing hole with 5/8-inch bit. Be careful to drill only the tubing hole and not the
working end of the hole.
REMOVAL
WARNING: Perform fuel pressure release procedure before disconnecting coupling.
NOTE: Before disconnecting, locate white indicator ring, which may have slipped down length of fuel tube.
1. Fit Spring Lock Coupling Disconnect Tool T83P-19623-C to coupling so that tool can enter cage to release the garter spring.
2. Push the tool into the cage opening to release the female fitting from the garter spring.
3. Pull the coupling male and female fittings apart.
4. Remove the tool from the disconnected spring lock coupling.
INSTALLATION
