F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Parking Brake Control: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the cowl side trim panel.
3. Disconnect the parking brake signal switch and bracket connector at the parking brake control.
4. Relieve tension on the parking brake system by having an assistant pull directly rearward on the intermediate cable until all front parking brake
cable and conduit is unwound from the parking brake control. Be careful not to damage the coating on the parking brake cable.
Pin Location
5. Insert a 4-mm (0.156-inch) drill bit or equivalent size pin into the hole provided in the parking brake control.
6. Remove the three nuts holding the parking brake control to the steering column support bracket. Pull the parking brake control away from the
steering column support bracket.
7. Raise and support the vehicle.