F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
3. Install the input shaft bearing with the metal side covering the rollers facing outward. Seat the bearing in the valve housing using Seal Replacer
T65P-3524-A1. Be sure the bearing rotates freely.
4. Dip a new oil seal in gear lubricant, MERCON(R) Power Steering Fluid XT-2-QDX or MERCON(R) equivalent and place it in the housing with
the metal side facing outward. Drive the seal into the steering gear housing until the outer edge does not quite clear the snap ring groove.
5. Place the snap ring in the housing and drive on the ring using Seal Replacer T65P-3524-A1 until the snap ring seats in its groove.
6. Place the dust seal in the housing with the dished side (rubber side) facing out. Drive the dust seal into place using Seal Replacer T65P-3524-A1.
When properly installed, the seal will be located behind the undercut in the power steering gear input shaft and control.
7. Apply a generous amount of Ford Multi-Purpose Grease DOAZ-19584-AA or equivalent meeting Ford specification ESB-M1C93-A to the area
between the two seals.