F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
11. Using the O-Ring tool, remove the forward clutch piston inner seal.
ASSEMBLY
NOTE: Soak the clutch plates for 15 minutes in clean Motorcraft MERCON or MERCON V Automatic Transmission Fluid or equivalent meeting
FORD specification.
1. Install the forward clutch piston inner seal.
2. Inspect the forward clutch piston check ball.
-
Check for freedom of movement and proper seating.
-
Clean with a suitable solvent, if necessary.
-
Replace the forward clutch piston assembly, if necessary.
3. Install the forward clutch piston outer seal.
NOTE: Make sure the seal lip is facing upward.