F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Clutch: Service and Repair
Center Support Clutch
DISASSEMBLY
1. Remove two direct clutch seal rings and No. 6 center support thrust washer.
2. Inspect No. 6 center support thrust washer, center support seal ring grooves, hub inner and outer diameters and feedbolt threads for contamination
or damage. Clean or replace as necessary.
3. Inspect ball bearing inside center support for damage. Service as required.
ASSEMBLY
1. Install No. 6 center support thrust washer using a light film of petroleum jelly to hold in place.
2. Install two new direct clutch seal rings.
Coast Clutch
NOTE: MERCON Automatic Transmission Fluid is being replaced by MERCON V as a service fluid.