F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
16. Clean and check condition of transmission pan magnet. Position pan magnet over dimple in transmission pan.
17. Clean, inspect and reuse elastomeric gasket unless damaged.
CAUTION: Cork gaskets and elastomeric gaskets are not interchangeable. If you remove a cork gasket, replace it with a cork gasket. If you
remove an elastomeric gasket, clean, inspect and reuse unless gasket is damaged. Be careful not to cut or bend elastomeric gasket.
18. Install transmission pan, gasket and bolts using a 10 mm socket. Tighten bolts to 14-16 Nm (10-12 ft lbs.).
19. Remove safety stands and lower vehicle.
20. Fill the transmission to proper level with Motorcraft MERCON or MERCON V Automatic Transmission Fluid or equivalent meeting FORD
specification.
21. Check shift cable adjustment.