F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Valve Body: Service and Repair
Installation
NOTE: MERCON Automatic Transmission Fluid is being replaced by MERCON V as a service fluid.
1. Apply a light film of petroleum jelly to valve body separator plate to hold new valve body separator plate gasket.
2. Apply light film of petroleum jelly to valve body separator plate to hold new valve body separator plate to case gasket on valve body separator
plate.
3. Place a small amount of petroleum jelly on each of the eight rubber check balls and the steel EPC check ball. Position balls on the valve body
separator plate as shown.
4. Place a daub of petroleum jelly on the EPC check ball spring and install it into the location shown.
