F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
6. Utilize pinion shims as the gauge for shim selection. This will minimize errors in attempting to stack feeler gauge stock together or simple addition
errors in calculating correct shim thickness. A slight drag should be felt on the pinion shim for correct selection. Do not force the pinion shim
between the Gauge Block T80T4020-F42 and the Gauge Tube D81T4020-F51 or equivalent. This will minimize selection of a pinion shim thicker
than required which results in a deep tooth contact in final assembly of integral axles.
NOTE: The same differential pinion bearing used in the following procedure must be used in final assembly of the axle.
NOTE: Make sure the press load is not applied to the bearing cage.
