F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Shifter M/T: Service and Repair
Shift Lever Housing
1. If required, install a new detent in the shift lever housing. Using Rotunda Heat Gun 107-R0300 or equivalent.
NOTE: Disassembly of parts inside the shift lever housing should be confined to replacement of the detent when necessary.
2. Heat the detent mounting area in the shift lever housing to approximately 120° C (248° F). Press the detent into its mounting hole until it rests
against its stop in the base of the hole.