F 350 2WD Pickup V8-7.3L DSL (1988)
Water In Fuel Indicator: Description and Operation
WAIT TO START LAMP
The "WAIT TO START" lamp comes on when the ignition switch is turned to the RUN position, and the engine is below normal operating temperature.
It will remain lit for 4 to 10 seconds, depending on engine temperature. If the engine is at or above normal operating temperature the lamp will not turn
on.
NOTE: If the ignition switch is left in the ON position for an extended period of time or the engine is not started within the two minute cycle time, the
glow plug system must be reset by turning the ignition switch to the OFF position.
FUEL FILTER RESTRICTION LAMP
This engine is equipped with a fuel filter restriction sensor. A restriction indicator lamp is located in the instrument panel to alert the driver.
WATER IN FUEL LAMP
The "WATER IN FUEL" warning lamp should turn on when the ignition switch is in the START position to indicate proper lamp and sensor function.
The lamp will come on if the fuel filter/water separator has a significant amount of water in it. If the lamp comes on during normal engine operation,
drain the fuel bowl in the filter as soon as possible. Water in the fuel could cause extensive damage to the fuel injection system.
