F 350 2WD Super Duty V10-6.8L (2009)
1. For additional information, refer to the procedures.
Camshaft Roller Follower
Camshaft Roller Follower
Removal
All camshaft roller followers
1. Depending on the camshaft roller follower being serviced, remove the LH or RH valve cover. For additional information, refer to Valve Cover -
LH See: Cylinder Head Assembly/Valve Cover/Service and Repair/Valve Cover - LH or Valve Cover - RH See: Cylinder Head Assembly/Valve
Cover/Service and Repair/Valve Cover - RH.
2. Rotate the crankshaft until the piston for the valve being serviced is at the top of its stroke with the intake valve and the exhaust valves closed.
Cylinder No. 7 front intake valve roller follower
3. NOTICE: The balance shaft bearing caps must be installed in their original locations or engine damage may occur. Record camshaft
bearing cap locations.
Remove the 6 bolts in the sequence shown, the 3 bearing caps and the balance shaft.
4. Remove the 2 bolts and the camshaft roller follower.
Cylinder No. 10 front intake valve roller follower
