F 350 2WD Super Duty V10-6.8L VIN S (1999)
Keyless Entry Transmitter: Service and Repair
PROGRAMMING
NOTE:
-
All keyless entry remote transmitters must be programmed at the same time.
-
To program (or reprogram) the keyless entry remote transmitters into the Generic Electronic Module (GEM), perform the following steps.
1. Turn the ignition from OFF to RUN five times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock
and unlock all the doors.
2. Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote
transmitter has been programmed.
3. If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.
4. Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter
has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.