F 350 2WD Super Duty V10-6.8L VIN S (1999)
Audible Warning Device: Service and Repair
Key-In-Ignition Warning Switch
REMOVAL
1. Replace the brush assembly.
NOTE: For motorhome, the key-in-ignition warning switch and brush are replaced as an assembly.
2. Remove the ignition switch lock cylinder.
1
Insert the ignition key and turn to the RUN position.
2
Insert a punch in the access hole of the steering column and press the release tab while pulling out the ignition switch lock cylinder.
3. Remove the key-in-ignition warning switch.
1
Pry the clip downward.
2
Release the key-in-ignition warning switch from the rear of the ignition switch lock cylinder.
INSTALLATION