F 350 2WD Super Duty V10-6.8L VIN S (1999)
7. Using the C-Frame and Screw, press the bearing cup until the opposite bearing cup can be positioned on the spider trunnion.
8. Position the bearing cup on the spider in the centering flange yoke.
9. Press the bearing cup into position.
10. CAUTION: The final bearing cup will require centering due to spring pressure.
NOTE: Position the jaws of the Differential Bearing Cone Remover into the driveshaft center yoke bearing cup bores.
Use the Differential Bearing Cone Remover and Step Plate and hand tighten the Differential Bearing Cone Remover to center the spider trunnion
in the bore.