F 350 2WD Super Duty V10-6.8L VIN S (1999)
5. NOTE: If the bearing cup cannot be pressed all the way out, remove it with gripping pliers.
Remove the driveshaft slip yoke.
1
Position the driveshaft into the C-Frame and Screw.
2
Press out a bearing cup.
3
Rotate the driveshaft 180 degrees.
4
Press on the spider to remove the bearing cup from the opposite side.
5
Remove the driveshaft slip yoke.
6. Remove the remaining bearing cups and spider.
7. Clean the driveshaft yoke area at each end of the driveshaft.
^
Inspect the driveshaft and driveshaft components for wear or damage.
Assembly
NOTE: Universal joint service kits are to be installed as complete assemblies only. Do not use components from other universal joints.
1. Install a new bearing cup.
1
Start a new bearing cup into the driveshaft yoke.
2
Position a new spider in the driveshaft yoke.
3
Install the driveshaft into the C-Frame and Screw.
4
Press the bearing cup just below the snap ring groove.