F 350 2WD Super Duty V10-6.8L VIN V (2005)
Brake Pad: Service and Repair
Brake Pads
Material
Removal
1. If necessary, remove the brake fluid until the brake master cylinder reservoir is half full.
2. Remove the wheel and tire assembly.
3. CAUTION: Do not pry in caliper sight hole to retract pistons as this can damage the pistons and boots.
CAUTION: When removing the brake caliper, never allow it to hang from the brake flexible hose. Provide a suitable support.
Remove the 2 brake caliper bolts and position the caliper aside.
4. NOTE: Install a new pads if they are worn past the specified thickness. Install new pads in complete axle sets.
Remove the brake pads and retraction clips.
5. Measure the brake disc thickness.
^
Install a new brake disc if not within specification.