F 350 2WD Super Duty V10-6.8L VIN V (2005)
^
Stage 1: Tighten to 9 Nm (80 inch lbs.).
^
Stage 2: Tighten an additional 90 degrees.
7. Install the 4 lower TB spacer bolts in 2 stages:
^
Stage 1: Tighten to 9 Nm (80 inch lbs.).
^
Stage 2: Tighten an additional 90 degrees.
8. Install a new gasket and the throttle body (TB).
Tighten the 4 bolts in 2 stages:
^
Stage 1: Tighten to 9 Nm (80 inch lbs.).
^
Stage 2: Tighten an additional 90 degrees.
9. Position the intake manifold runner control (IMRC) actuator and install the 3 bolts.
^
Tighten to 10 Nm (89 inch lbs.).
10. Install the IMRC rod C-clip.
