F 350 2WD Super Duty V10-6.8L VIN V (2005)
Alignment: Service and Repair
Lean Correction - Rear
Lean Correction - Rear
1. NOTE: Rear side lean can be adjusted by installing shims on the low side. A vehicle that is low at the rear can be raised by installing shims at
both sides. The following shims are available:
^
D7TZ-5742-A - 10 mm (0.39 inch)
^
3C4Z-5A300-AA - 13 mm (0.51 inch)
^
5C3Z-5A313-AA - 25 mm (0.98 inch)
Raise and support the vehicle frame until the weight is off the rear springs but with the tires still touching the floor.
2. Support the axle.
3. Remove and discard the four nuts and two U-bolts to allow the rear axle to separate from the rear spring.
4. Turn the shim so the recess is facing upward.