F 350 2WD Super Duty V10-6.8L VIN V (2005)
8. Install the seat backrest trim panel.
1
Position the seat backrest trim panel to the seat backrest and lift up, engaging the upper retaining clips.
2
Push the sides of the seat backrest trim panel together, align the retaining clips to the seat backrest frame wires and release the cover, engaging
the retaining clips into the seat backrest frame wire retainer.
3
Install the seat backrest trim panel pin-type retainers.
9. Position the side trim cover onto the seat.
-
Vehicles with power seat, feed the seat control switch wire harness through the seat opening as noted in removal.
-
Align the side shield to the pivot bolt.
Vehicles with heated seat
10. Connect the heated seat switch electrical connector.