F 350 2WD Super Duty V10-6.8L VIN V (2005)
1
Using the special tool, remove the bolt.
2
Remove the front passenger side safety belt anchor.
Crew Cab vehicles
12. NOTE: Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or the cover does not remain
closed, install a new shoulder safety belt guide cover.
Remove the driver side shoulder safety belt guide.
1
Open the cover.
2
Remove the nut.
3
Remove the shoulder safety belt guide.
13. Remove the driver side front and rear door scuff plates and the B-pillar trim panel.
14. Remove the safety belt retractor.
1
Using the special tool, remove the bolt.
2
Pivot up at the bottom and remove the safety belt retractor.
Installation
Crew Cab vehicles
1. CAUTION: Do not remove the shipping clip until the shoulder safety belt guide is secured in position. Allowing the safety belt to be
retracted further into the safety belt retractor may cause the safety belt retractor to lock and not release the safety belt.
NOTE: Make sure that after an automatic locking retraction (ALR) retractor is installed that the retractor is not in the ALR mode of operation
when installed.