F 350 2WD Super Duty V10-6.8L VIN V (2005)
Lightly lubricate the retained feed bolts with clean transmission fluid. Loosely install the bolts. Do not tighten to specification at this time. See
Figure 44.
8.
Using Special Tool Retaining Ring Pliers 307-343, install the center support snap ring. See Figure 45.
The snap ring should be installed with the flat edge facing downward. The gap in the snap ring should be facing the 6 o'clock position. Tap the
snap ring securely into the case.
9.
Tighten the feed bolts to 32 Nm (24 lb-ft). See Figure 46.