F 350 2WD Super Duty V10-6.8L VIN V (2005)
Vehicles with circular flange
2. NOTE: Align the index marks.
NOTE: Bolt direction is vehicle application dependent.
Position the driveshaft flange and loosely install 4 new bolts.
-
Tighten to 111 Nm (82 lb-ft).
Vehicles with split pin yoke
3. NOTE: Align the index marks.
Install the 2 new retainers and 4 new driveshaft-to-axle bolts.
-
Tighten to 35 Nm (26 lb-ft).
Vehicles with circular flange
4. Install the 4 new bolts.
-
For automatic transmissions, tighten to 103 Nm (76 lb-ft).
-
For manual transmissions, tighten to 111 Nm (82 lb-ft).
Driveshaft - Rear, Two-Piece
Driveshaft - Rear, Two-Piece
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Index-mark the driveshaft at the axle flange.
3. Remove and discard the four driveshaft bolts. Disconnect the driveshaft from the axle flange.
^
Using mechanic's wire, support the driveshaft.
