F 350 2WD Super Duty V10-6.8L VIN V (2005)
11. To aid the tool in cutting the urethane adhesive along the cowl, insert the Pumper tool at the top center of the windshield and inflate.
12. Insert the Interior Auto Glass Cut-Out Knife into the bottom of the urethane adhesive and cut from corner to corner.
13. WARNING: Removing the windshield glass requires more than one technician.
NOTE: If reinstalling the windshield glass, tape the windshield at the windshield stops to aid in alignment of the glass during installation.
Carefully remove the windshield glass from the vehicle and place on a stable work surface.
Installation
1. Dry-fit the new windshield glass on the existing urethane bead on the pinchweld.
1
Position the windshield glass on the pinchweld.
2
Center the windshield glass in the opening.
3
Adjust the setting blocks as needed for best fit.
4
Using tape or non-permanent marker, make alignment marks (preferably at the setting blocks) on the windshield glass and the body.
2. After the dry-fit alignment, remove the glass and moulding assembly from the windshield opening and place on a stable work surface with the
interior side of the glass facing up.
3. Using a clean rag, brush or oil-free compressed air, to clean the pinchweld area around the existing urethane. Remove any foreign material or
water that may have entered during windshield removal.
