F 350 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Brake Rotor/Disc: Service and Repair
Front
Brake Disc
Disc - F-250, F-350 4x2
Removal
1. Remove the disc brake caliper anchor plate.
2. Remove the disc brake rotor as follows:
1
Remove the hub grease cap.
2
Remove the cotter pin.
3
Remove the nut retainer.
4
Remove the spindle nut.
5
Remove the outer wheel bearing retainer washer.
6
Remove the outer wheel bearing.
7
Remove the disc brake hub and rotor.
3. If necessary, resurface the disc brake hub and rotor. Ford recommends on-vehicle rotor machining.
1
Remove the wheel hub grease seal.
2
Remove the inner wheel bearing.
Installation
1. Thoroughly clean and inspect the front wheel bearings and the disc brake hub and rotor.
-
Use Metal Brake Parts Cleaner F6AZ-2C41O-AB or equivalent.