F 350 2WD Super Duty V8-5.4L VIN 5 (2006)
Crew Cab Vehicles
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters, [if
so equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted.
The automatic locking retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR
feature for a child seat is functioning correctly, in addition to other checks for correct safety belt system function. A new belt and retractor
assembly must be installed if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating
correctly when inspected according to the functional inspection procedures. Failure to install a new belt and retractor assembly could increase
the risk of injury in collisions.
Regular cab vehicles
1. NOTE: Inspect the D-ring cover for damage. If the cover is damaged or does not remain closed, install a new D-ring cover.
Open the D-ring cover.
2. Remove the nut and the D-ring.
