F 350 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
b.
If a PID reading other than 255 or 100 displays, replace only the sensor that is out of specification. Refer to Workshop Manual Section
413-00 as needed for removal and installation procedures.
ACCESSING PIDS WITH NGS, SELECT:
^
Vehicle Line
^
Diagnostic Data Link
^
PAM
^
PID/Data Monitor And Record
^
Select The Appropriate PIDS
^
Start
ACCESSING PIDS WITH WDS, SELECT:
^
Tool box Icon
^
Datalogger, Then Tick (Check Mark)
^
Modules, Then Tick
^
PAM, Then Tick
^
Select The Appropriate PIDS, Then Tick
NOTE
FOR SOME VEHICLES, REPLACEMENT SENSORS WILL BE RECEIVED WITH A PRIMED-BLACK PAINTABLE SURFACE AND MUST
BE PAINTED TO MATCH VEHICLE COLOR.
REFER TO PAINTING INSTRUCTIONS BELOW.
PAINTING INSTRUCTIONS
^
Use a Ford-Approved paint gun, apply base/clear coat to match vehicle
^
Surface can be cleaned with Isopropyl alcohol
^
Maximum paint curing temperature is 194~ F (90~ C) for 1 hour
^
Maximum coating thickness 125 micro meters (including the primer)
^
Paint or veil of paint must not get into connector
^
Immersion processes ARE NOT permitted
^
Paint must be applied evenly to the surface
^
Functional test must be done after painting
^
Use NGS tester to confirm settling time of the sensor is within the specified limits: 850 micro sec. to 1500 micro sec.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
050604A
2004-2005 F150,
0.7 Hr.
2002-2005 Excursion, 2002
Expedition/Navigator,
2002-2005 F Super Duty,
2002-2003 Blackwood,
2005 Freestyle: Replace