F 350 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
help remove any foreign material trapped in the fluid coolers.
Refill
4. Use only clean automatic transmission fluid.
5. Once the fluid exchange has been completed, disconnect the flush and fill machine. Reconnect any disconnected fluid cooler tubes.
6. With the engine running and the transmission at normal operating temperature 66 - 77°C (150 - 170°F), check and adjust the transmission fluid
level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is achieved (fluid should be
in the cross-hatched area of the fluid level indicator).
Draining
Vehicles equipped with a fluid pan and torque converter drain plug
1. With the vehicle in NEUTRAL position it on a hoist. For additional information, refer Maintenance/Service and Repair.
2. Remove the drain plug and allow the fluid to drain.
3. Remove the torque converter drain plug cover.
4. Remove the torque converter drain plug and discard.
All vehicles
5. Allow the fluid to drain.
6. NOTE: If equipped with a radiator in-tank transmission fluid cooler, the cooler will need to be flushed.
Only flush the cooler tubes, in-tank fluid cooler and the bypass valve if carrying out a transmission overhaul. Vehicles equipped with auxiliary
OTA coolers cannot be flushed completely. Only new coolers should be installed.