F 350 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
17.
Apply electrical grease to the face of the connector, forcing a small amount into all three (3) terminals.
18.
NOTE: The new connector is equipped with a new weather seal. Before connecting the EP sensor, make sure the original weather seal is not stuck
on the sensor. If the original weather seal is left in place, it will impair connector attachment.
Connect the EP harness connector.
19.
NOTE: If there is any oil residue, use Motorcraft Metal Brake Parts Cleaner, PM-4, to clean both connecting ports and the inside surface of the
charge air cooler tube to prevent the tube from blowing off.
Install the CAC outlet tube. Tighten the clamps to 12 Nm (9 lb-ft).
20.
Install the air filter and outlet tube assembly. Tighten the clamps to 4 Nm (35 lb-in).
21.
Proceed to Module Recalibration in this Attachment IV.
MODULE RECALIBRATION
NOTE:
This recalibration, using WDS software Version B40.7 or higher, or B41.1 or higher, will update the PCM, TCM and FICM. This new calibration is
not included in the B41 CD. Calibration files may also be obtained at the website.
1.
Connect a battery charger to the vehicle.
2.
Using Worldwide Diagnostic System (WDS), recalibrate the modules to the latest level calibration.
3.
VERIFY THE WDS IS LOADED WITH SOFTWARE VERSION B40.7 OR HIGHER, ORB41.1 OR HIGHER.
4.
Select Module Configuration Programming (MCP) and follow the WDS display instructions.
^
If unable to recalibrate the modules:
-
module replacement will not be covered under this program.
-
prior to disconnecting the WDS from the vehicle and closing the session, call the Special Service Support Center.
5.
Perform a self-test to verify there are no further concerns.
6.
Proceed to Road Test Procedure in this Attachment IV.
ROAD TEST PROCEDURE
Check OASIS to verify there are no other Field Service Actions applicable to this vehicle prior to performing the Road Test Procedure.
Test drive the vehicle to make sure no drivability concerns exist prior to returning the vehicle to the owner.
NOTE:
To address any customer concerns for vehicles that are out of warranty and exhibit engine performance issues after the road test, please follow the
guidelines in the Warranty and Policy Manual.
AUTHORIZED MODIFICATIONS LABEL INSTALLATION