F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
-
Tighten to 31 Nm (23 lb-ft).
Late build vehicles
23. Connect the hose to the EGR cooler.
24. Connect the EGRT sensor electrical connector.
Early build vehicles
25. Install the retaining clip and retaining nut on the stud.
-
Tighten to 12 Nm (106 lb-in).
26. Connect the EGRT sensor electrical connector. Connect the EGR cooler hose and connect to the retaining clips.
-
Tighten to 4 Nm (35 lb-in).
All vehicles
27. NOTICE: Do not bend or twist the Exhaust Gas Recirculation (EGR) cooler bellows or damage to the EGR cooler may occur.
NOTE: Inspect the corrugation of the vertical EGR cooler inlet to make sure that the corrugation ribs are not touching and are not damaged.
Install the 2 nuts for the vertical EGR cooler.