F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
9. Disconnect the crankcase vent oil separator tube from the crankcase vent oil separator.
10. Remove the 4 bolts and the crankcase vent oil separator.
-
Remove and discard the press-in-place gasket.
11. Disconnect the heater hose from the heater supply tube.
12. Remove and discard the 3 pushnuts. Remove the glow plug module heat shield.
13. Remove the 2 bolts from the fuel rail supply tube retainers.
14. NOTICE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. To prevent fuel system damage, it is
essential that absolute cleanliness is observed when working with these components. Always install Fuel System Caps to any open orifices
or tubes.
