F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
30. NOTE: Install a new O-ring seal.
Install the EGR cooler coolant tube and bolt.
-
Tighten to 10 Nm (89 lb-in).
31. NOTE: It may be necessary to position the tensioner to install the lower bolt. Install the lower bolt last.
Position back the FEAD assembly. Install the 2 nuts and 2 bolts.
-
Tighten to 47 Nm (35 lb-ft).
32. NOTE: Raise the supply tube up to clear the ECT sensor connector when repositioning the power steering pump.
NOTE: Make sure the power steering pressure tube retainer is on the retaining stud prior to tightening the bolts for the power steering pump.
Position back the power steering pump and install the 3 bolts.
-
Tighten to 25 Nm (18 lb-ft).
33. Install the retaining nut for the power steering hose and tube.
-
Tighten to 25 Nm (18 lb-ft).
34. NOTICE: Use a back-up wrench to prevent the fittings in the high-pressure fuel injection pump from turning. If the fittings move, the
