F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
13. NOTICE: Make sure the correct bolts are installed in the bracket or damage to the bracket can occur.
Position the 2 EGR-OC pipe and loosely install the 2 new bracket bolts. Install a new gasket and loosely install the 2 new bolts.
14. Install the 3 new RH turbocharger inlet pipe-to-exhaust manifold nuts.
-
Tighten to 31 Nm (23 lb-ft).
15. Install the EGRT sensor into the RH turbocharger inlet pipe.
-
Tighten to 44 Nm (32 lb-ft).
16. Install the RH fender splash shield.
17. Install the RH front tire and wheel. Carry out Wheel and Tire - Single Rear Wheel (SRW) or Wheel and Tire - Dual Rear Wheels (DRW).
18. NOTICE: Failure to install and correctly tighten the Exhaust Gas Recirculation (EGR)-Oxidation Catalytic Converter (OC) pipe support
bolts will result in damage to the horizontal EGR cooler and possible engine damage.
Install the bracket, washers and loosely install the 2 new bolts for the EGR-OC pipe bracket.