F 350 2WD Super Duty V8-7.3L DSL Turbo VIN F (1999)
Disconnect the driveshaft at the rear axle, and position it aside.
3. NOTE: Index mark the flange (end yoke for Motorhome) to the pinion shaft.
While using a suitable tool to prevent the flange or yoke from turning, remove the pinion nut.
4. Using the 2-Jaw Puller, remove the flange or yoke.
5. Using the Seal Remover and the Impact Slide Hammer, remove the pinion seal.
6. Clean the rear axle pinion seal seat.
Installation
1. CAUTION: Installation without the proper tool can result in early seal failure. If the pinion seal becomes cocked during installation,
remove and install a new one. Use care to ensure the garter spring remains in place during assembly. If the spring is dislodged, the pinion
seal must be replaced.
NOTE: Drive the pinion seal into the housing, using the Pinion Oil Seal Replacer.
