F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
Camshaft Bearing: Service and Repair
Rear Bearing Cover
REMOVAL
1. On a vehicle with a manual transmission remove the transmission, flywheel housing, clutch pressure plate and clutch disc.
On a vehicle with an automatic transmission, remove the transmission.
2. Remove the flywheel attaching bolts and remove the flywheel. Remove the engine rear plate.
3. Replace the camshaft rear bearing cover.
INSTALLATION
1. Coat the flywheel attaching bolts with oil-resistant Threadlock(R) and Sealer EOAZ-19554-AA or equivalent meeting Ford specification
WSK-M2G315-A5 (Type II). Install engine rear plate. Install flywheel. Install and tighten the attaching bolts in sequence, across from each other
to 102-115 Nm (75-85 ft. lbs.).
2. On a vehicle with a manual transmission, install the clutch pressure plate, clutch disc, transmission, and the flywheel housing.
3. On a vehicle with an automatic transmission, install the transmission.
