ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Thermostat - Replacement Recommendations|Page 1436 > < Thermostat - Replacement Recommendations
Page 1
background image

Thermostat: All Technical Service Bulletins
Thermostat - Replacement Recommendations

Article No. 84-5-18-S

THERMOSTAT (6.9L DIESEL) - REPLACEMENT

LIGHT TRUCKS 1983-84 E & F SERIES

This article is being re-issued to present illustrations of acceptable and non-acceptable replacement thermostats.

Figure 25

Figure 26

Replacement thermostats other than the specified Motorcraft or International Harvester thermostats may result in engine overheat damage. The specified
thermostat (Figure 25) does not contain an internal by-pass, since a by-pass with an integral check ball is located in the cylinder block. If the technician
installs an aftermarket thermostat with a "will fit" design that has a flat washer secured to the power pill (Figure 26) the thermostat will block off a water
passage, causing engine overheat and possible damage.
Therefore, whenever the thermostat is replaced, it is mandatory that only the specified Motorcraft E3TZ- 8575-A or International Harvester 1803357
C91 thermostat be installed.

PART NUMBER

PART NAME

CLASS

E3TZ-8575-A

Thermostat

A

ARTICLE SUPERSEDED: 84-5-18
WARRANTY STATUS: "INFORMATION ONLY"

Thermostat - Replacement Recommendations|Page 1436 > < Thermostat - Replacement Recommendations