F 350 4WD Pickup V8-7.3L DSL (1988)
7.
If a clear coat is applied, use 9500S.
DUPONT CENTARI MONO-COAT ENAMEL SYSTEMS
PREPARATION
1.
Wash the surface thoroughly with a mild detergent.
2.
Clean with Prep Sol.
TOPCOATING (Follow Manufacturer's Recommendation)
1.
Add 8 parts of Centari enamel color and 1 part 793S hardener.
2.
Add 4 parts of (8022S, 8093S, or 8096S) reducer, depending on shop temperature.
3.
Add 355S flex additive per label instructions.
4.
Mix thoroughly.
5.
Spray 2-3 wet coats, with 5 minutes flash time, at 50-65 PSI.
BASF PRODUCTS
The following procedure is applicable to 4 paint systems in the BASF paint line. Read individual "system" instructions carefully.
PREPARATION
1.
Solvent wipe the molding with RM Pre-klean-o 900.
2.
Sand with 400 grit sand paper and rinse with 901 pre-paint cleaner.
TOPCOATING BASECOAT
^
"Glasurit" 54-line color
2 vol. parts
^
54-line reducer
1 vol. part
^
"Diamont" basecoat color
2 vol. parts
^
B R Diamont reducer
2 vol. parts
^
"Miracryl" basecoat color
2 vol. parts
^
BCR reducer
2 vol. parts
^
"Supreme Gold" basecoat color
2 vol. parts
^
LBR reducer
2 vol. parts
Apply basecoat color until hiding is achieved. Allow 3-5 minutes flash time between coats.
NOTE:
USE APPROPRIATE REDUCER FOR SHOP CONDITIONS. ALLOW 15 MINUTES FLASH-OFF BEFORE SPRAYING CLEARCOAT.
TOPCOATING
Apply clearcoat per manufacturer's label instructions:
CLEARCOAT REDUCTIONS
^
DC-88 Diamont Clear
4 Vol. Parts
^
DH-44 Diamont Hardener
1 Vol. Part
^
MC-1000 Clear
4 Vol. Parts
^
894 Hardener
1 Vol. Part
^
LC-1300 Supreme Gold Clear
4 Vol. Parts
^
LH-1301 Hardener
1 Vol. Part