F 350 4WD Pickup V8-7.3L DSL (1988)
Output Shaft: Service and Repair
Removal and Installation
REMOVAL
CAUTION: All parts must be handled carefully to avoid nicking or burring the bearing or mating surfaces. Lubricate all internal parts with clean
automatic transmission fluid before assembling them. Do not use any other lubricants except on gaskets and thrust washers. These may be coated with
petroleum jelly to facilitate assembly. Always use new gaskets and seals when assembling transmission.
Output Shaft Disassembled
1. Remove governor, refer to the Output Shaft Disassembled image.
2. Remove snap ring that secures governor distributor on output shaft and slide it off front of shaft.
3. Remove seal ring from distributor.
INSTALLATION
1. Reverse procedure to install.