F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
14. Remove the rocker arm and steel ball from the rocker arm pedestal.
INSTALLATION
1. Assemble the intake rocker arm or exhaust rocker arm assembly as follows:
a. Place the steel ball in the rocker arm cup and lubricate it with clean engine oil.
b. Place the rocker arm pedestal on the steel ball.
Rocker Arm Cutaway View
c. Snap the retaining clip over the rocker arm pedestal groove.
2. Lubricate the push rod ends with engine oil and install the push rod (copper end up).
CAUTION: Failure to follow the next step of this procedure could result in bent valves.
3. Rotate the engine until the mark on the crankshaft damper is at 11 O'clock to prevent valve damage when installing the intake rocker arm and
