F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
5.
Position the flanged idler pulley (19A216) to A/C-P/S bracket (19E708). Be sure the cutout in the rear flange is positioned around the body of the
tensioner assembly. Tighten idler pulley bolt to 55 N-m (40 ft-lb). See Figure 4.
6.
Position vacuum pump and install original retaining bolts. Tighten bolts to 27 N-m (20 ft-lb). See Figure 5.
7.
Install vacuum pump pulley using Steering Pump Pulley Replacer T65P-3A733-C or equivalent so the pulley hub is flush to the end of the shaft +/-
.010 inch.