F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
1.
Install the belt guide (8680) as follows (Refer to Figure 1):
a.
Remove the vacuum pump pulley using Steering Pump Pulley Remover T69L-10300-B or equivalent.
b.
Remove two vacuum pump retainer bolts: the center one and the one towards the right side of the vehicle.
c.
Position and secure the guide to the front of the pump using the removed bolts. Tighten bolts to 27 N-m (20 ft-lb). Refer to Figure 1.
d.
Press on vacuum pump pulley using Power Steering Pulley Replacer T65P-3A733-C or equivalent, so the end of the pump shaft is flush with
the pulley hub (+/- 0.010 inch).
2.
Position and install the tensioner (6B209) to the A/C-P/S bracket. Tighten T-50 Torx-head bolt to 55 N-m (40 ft-lb). See Figure 1.