F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
3.
At the cable bracket on the plenum heater core cover, cut away the bracket using a hacksaw blade or similar tool. Refer to Figure 1.
4.
Remove the 5/16" headed screw from the top of the cam. Discard the cam and screw with spring clip. Refer to Figure 2.
5.
At cam post, add post extension and secure with the new screw, torquing the screw to 1.7 N.m (15 lb.in). Refer to Figure 1.
6.
Remove the upper left screw securing the plenum heater core cover and install the A/C plenum chamber support bracket between the ribs to the
right side of the bracket which was cut off. Make sure the hole from the previously removed screw is lined up with the hole in the plenum chamber
support bracket. Refer to Figure 1.
INSTALLATION
1.
At the plenum chamber, move the temperature door arm to the "full warm" position (counterclockwise) and be sure it remains there throughout the
installation procedure. Refer to Figure 1.
