F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Steering Pump, Power Removal
1. Remove power steering return hose (3A713) at the pump and drain fluid.
2. On F-Super Duty only, also remove power steering return line hose (3A005) at the pump and drain fluid.
3. Remove the power steering pressure hose by unscrewing the connector from the pump.
4. Remove drive belt. Refer to the procedure described in this section.
5. Remove the power steering pump pulley as outlined in this section.
6. Remove power steering attaching bolts and remove the power steering pump.
Installation
1. Position the power steering pump and install and tighten all attaching bolts. Refer to illustrations for bolt torques.
2. Install the power steering pump pulley as outlined in this section.
3. Install drive belt. Refer t6 the procedure described in this section.
.
Install the pressure hose tube nut into the pump outlet fitting and tighten to 45-54 N.m (30-40 ft-lb).
5. Connect power steering return hoses and reposition the clamps.
6. Fill the power steering oil reservoir with Premium Power Steering Fluid E6AZ-19582-AA (ESW-M2C33-F) or equivalent. Start the engine and
turn the steering wheel from left to right without hitting the stops to remove air from the system.
7. Check for leaks and recheck the fluid level. Add fluid if necessary to proper level as specified. See: Specifications