F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Disconnect the driveshaft from the front axle pinion flange. Securely wire the driveshaft to the frame.
9. Disconnect the vent tube at the axle housing. Plug the vent fitting.
10. On the right-hand side of the vehicle, remove the nut and bolt, and disconnect the tracking bar from the right-hand spring cap.
11. Carefully lower the twin-post hoist until the vehicle is approximately three feet from the floor.
WARNING: BEFORE PROCEEDING, MAKE SURE THE VEHICLE IS SECURELY SUPPORTED.
12. Position safety stands on the front coil springs (5310) about halfway between the front coil spring and the rear mounting shackle. Lower the
vehicle so the front springs rest on the safety stands.