F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Dana 44 And 50 Front Axle Assemblies (Exploded View)
REMOVAL
1. Raise the vehicle and install safety stands.
2. Remove the wheels and tires.
3. On vehicles equipped with 4-wheel anti-lock brakes, remove the front brake anti-lock sensor from the steering knuckle.
CAUTIONS:
-
After removal, the front disc brake caliper must be wired to the frame or otherwise supported to prevent suspending the front disc brake caliper
by the flexible hose.
-
If securing the front disc brake caliper is not practical, disconnect the brake hose from the front disc brake caliper. Plug the hose end to prevent
fluid loss and entry of air into the system. See: Brakes and Traction Control/Disc Brake System/Brake Caliper
-
Upon installation of the front disc brake caliper, bleed the brake system. See: Brakes and Traction Control/Brake Bleeding
4. Remove the front disc brake caliper, please refer to Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/ See:
Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair
5. Remove hub locks, wheel bearings, and lock nuts, please refer to Steering and Suspension/Suspension/Wheel Bearing/Service and Repair/ See:
Wheel Bearing/Service and Repair
6. Remove the front disc brake hub and rotor (1102) and front wheel bearing outer cone and roller (1216) from the front wheel spindle, please refer
to Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/ See: Brakes and Traction Control/Disc Brake
System/Brake Rotor/Disc/Service and Repair