F 350 4WD Super Duty V10-6.8L (2002)
![background image](/ford/f_350_4wd_super_duty/v10-6.8l/Page-2672007.png)
9. Install the upper steering column shroud.
10. Install the ignition switch lock cylinder.
^
Position the ignition switch lock cylinder to the RUN position.
^
Insert the ignition switch lock cylinder into the steering column.
^
Make sure the ignition switch lock cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position.
^
Make sure the ignition switch lock cylinder retaining pin is seated in the hole in the steering column.
^
Rotate the ignition switch lock cylinder through all positions to verify operation.
11. Install the lower steering column shroud.
1
Position the lower steering column shroud.
2
Install the screws.
12. Install the tilt wheel handle and shank.
13. Install the steering wheel. Do not install the driver air bag module at this time.